QUESTION

asked by
Matching network for SR4L034-L

Hi 

I want to implement  SR4L034-L in my board , 45*95mm , what is the recommended matching network..

can i send to you dxf/stp file? and you will simulate the board ?

Please log in or register to answer this question.

2 Answers

answered by
Hi

Thanks for your question.
Matching component values and topology will be specific to your device, as standard we always recommend the values used for the EVB in the data sheet as a starting point.
We are always keen to engage with our customers as early as possible in their design process and would be happy to review your gerber, stack up and 3D files and advise you further.
Please contact sales@antenova.com to get in touch with your regional sales representative who can help you with this.
commented by
edited by

I need tech support not sale support i already in contact with my distributor..

my board have 4 layers

commented by
Hi Netanbi,

Our engineers can support you directly on your project, but our process means you must go through your regional Sales Representative so we can get you the best and fastest response.
answered by
reshown by
do we need to do short between pin 2-3 sc1-2 or that the short is inside the antenna?

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.

download-guide-image

Antennas: The Comparison Guide

Find the perfect antenna for your project

Download
...