asked by
Matching network for SR4L034-L


I want to implement  SR4L034-L in my board , 45*95mm , what is the recommended matching network..

can i send to you dxf/stp file? and you will simulate the board ?

Please log in or register to answer this question.

2 Answers

answered by

Thanks for your question.
Matching component values and topology will be specific to your device, as standard we always recommend the values used for the EVB in the data sheet as a starting point.
We are always keen to engage with our customers as early as possible in their design process and would be happy to review your gerber, stack up and 3D files and advise you further.
Please contact to get in touch with your regional sales representative who can help you with this.
commented by
edited by

I need tech support not sale support i already in contact with my distributor..

my board have 4 layers

commented by
Hi Netanbi,

Our engineers can support you directly on your project, but our process means you must go through your regional Sales Representative so we can get you the best and fastest response.
answered by
reshown by
do we need to do short between pin 2-3 sc1-2 or that the short is inside the antenna?

Meet the moderators

Nansen Tsai

Engineering Manager Nansen has a wealth of technical RF and wireless knowledge, with particular expertise in RF development and problem-solving.

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.


Antennas: The Comparison Guide

Find the perfect antenna for your project