asked by
SR4L034-Matching , smith chart


so i get my board after production with SR4L034-R assembled in my design I matched the line to 50 ohm (pcb trace line) 

and also I assembled on the line the components like in the EVK  (pi network+inductor on t1 to gnd)

my question is how to match this wide band antenna ?

if I open spen from 600Mhz-2700Mhz how I now which component to change..

add pic from the van -smithchart and s11 , please advice :

Please log in or register to answer this question.

1 Answer

answered by
Hi Netanel,

This is a service we provide for our customers, you can send the device to us for optimisation and we can provide a full passive performance report including matching component values. I have passed your details on to your regional representative who will be in touch to assist.

Many Thanks


Meet the moderators

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.


Antennas: The Comparison Guide

Find the perfect antenna for your project