asked by
edited by
Hi. I will to conect to Quectel LC79D, pin 3 antenna out and 12456 to ground??
Hi, We need to conect a Raptor SR4G053 to a Quectel GNSS module LC79D.  Wich are wright way to conect the antenna pins?

Pin 3 to RF input of GNSS module?

Pins 2 3 4 5 and 6 to ground?

Thanks for your help in this mtter.

Best Regards fron Argentina.


Please log in or register to answer this question.

3 Answers

answered by
Hello Carlos,

Yes, connect Pin 3 to the input of the GNSS module.

NO, do NOT connect any of the other pins to ground.  They should all be floating pads. You can place pads under pins 1,2,4,5,6 on the opposite side of the board and run a through hole via to them for better mechanical strength but there should be not ground underneath or around the antenna.

Best regards,

Geoff S.
commented by
Thanks Geoff S.

Very clear your explanation. I will do that way.
answered by
I tested that the Pin 3 is electrically connected to  Pins  4, 5, 6. Is that OK? Pins 1, 2 are not.

Thanks for your assistance. Regards. Carlos
answered by
I tested that the Pin 3 is electrically connected to  Pin 3 4 5. Is that OK?

Thanks for your assistance. Regards. Carlos
commented by
Hi Carlos,

Yes, they are electrically connected through traces in the antenna itself. It is ok so long as all other pins are floating and NOT grounded.

Best regards,

Geoff S.

Meet the moderators

Nansen Tsai

Engineering Manager Nansen has a wealth of technical RF and wireless knowledge, with particular expertise in RF development and problem-solving.

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.


Antennas: The Comparison Guide

Find the perfect antenna for your project