QUESTION

asked by
m20048 configuration
I am using the m20048 in a custom board and would like to know if there is a firmware load or configuration that is required for the m20048. It is wired identically to the m20048-1 eval module (shown in application schematic example of the product specification document). I have applied 3.1V VCC and do not see any activity on the TX pin. Should I expect to see GPS traffic without any further software/firmware setup?

Please log in or register to answer this question.

1 Answer

answered by
Hi, You should be seeing NMEA data from the TX pin upon power up, did you also apply power to the backup pin? If you are still having issues please contact Antenova directly using techsupport@antenova.com

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.

download-guide-image

Antennas: The Comparison Guide

Find the perfect antenna for your project

Download
...