I am inquiring about the recommended printed circuit board layout for your surface mount antenna SR4L049.
The datasheet shows the top layer copper and clearance areas around the part.
I have been unable to find any information on the bottom side metalization.
Does the bottom layer require a clearance area directly underneath the part or is the bottom layer all ground?
Thank you for your time
Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.
Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.
