QUESTION

asked by
Performance of SR42I010 in proximity to metal
I am considering using a Grandis SR42I010 ISM antenna in a design with a GND plane of 90mm x 25mm located above a metal (zinc) casting. I can provide a separation of approximately 10mm from the metal. What effect is the metal likely to have on the overall performance of the antenna? Is there anything I can do to optimize performance?

Please log in or register to answer this question.

1 Answer

answered by
Hi Mark,

10mm is not that much for separation between the antenna and the metal object.  We typically recommend 15 to 20mm.  To optimize the performance the ground plane should be 115mm by 35mm. I would recommend cutting away some of the metal underneath the antenna out of the zinc casting to increase the distance between the antenna and the casting.

Best regards,

Geoff S.
commented by
Hi Geoff,

I understand your recommendation for a larger separation and increased ground plane. I will look into increasing the separation. I cannot remove metal but could possibly make the board taller so that the antenna is not directly above the underlying metal. I cannot make the board wider but might be able to extend the size to around 130mm x 25mm. I assume it is the total ground plane area that is important.

Mark
commented by
Hi Mark,

The length of the board is more important than the width when it comes to operation in the sub 1GHz band.
Separating the antenna from the metal even by 5mm will make a large difference in antenna performance.  I would not place the antenna any closer than that.

Best regards,

Geoff S.

Meet the moderators

Nansen Tsai

Engineering Manager Nansen has a wealth of technical RF and wireless knowledge, with particular expertise in RF development and problem-solving.

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.

download-guide-image

Antennas: The Comparison Guide

Find the perfect antenna for your project

Download
...