asked by
Matching PI configuration


I have this circuit matching.

The antenna is ANT3505B002TWPENS and the matching recommended is:

but, in my design I put the matching components with a PI configuration because I think is the best choice to match the 2 frecuencies (900 and 1800).

In first time we match 900Mhz with series C and parallel L (because this configuration have low influence at 1800 Mhz):

In second time we match 1800Mhz with parallel C and series L (because the this configuration have low influence at 900 Mhz):

And I remember that we can move across Smith´s chart with the next image:

Ok. We begin with our matching. In first time we calibrate our VNA (I have miniVNA Tiny).

I calibrate the short with 0 Ohm resistance at L8 and open L6:

I calibrate open with L6 open and L8 open:

And I calibrate 50 Ohm with a 50 Ohm resistor at L8 and L6 open:

Ok. Now we measure how is my circuit (shorting L6 and opening L8 and L9) and we have:

Point [1] is 900 Mhz and point [3] is 1800 Mhz.

My first impression is very bad because the 2 freceuncies are far of the center.

From now on I will put the exact value of the component to correct match although I solder and desolder components hundred of times to find the correct.

Now We begin with 900Mhz:

We have the 900Mhz frecuency at center, now we are going to match the 1800 Mhz.

Remember we can only use:

Because another configuration move the 900 Mhz frecuency and unmatch it.

And now I need to add an L in series to move the 1800Mhz at center of the circle, but, I don´t have any space to solder it with PI configuration.

I need to change my circuit matching configuration by this?

Why this data of the correct configuration by different frecuencies don´t tell at the datasheets of the antennas? I feel stupid because I design a complete circuit and now I discover that all is wrong.

More people make this mistake? With a PI configuration we can obtain a good matching, but, never a perfect matching?

Now I´m going to redesign the circuit and I need your advice J

Best regards (sorry about my english).

Please log in or register to answer this question.

1 Answer

answered by

Hello ,

This antenna is a competitor antenna so we can not provide assistance with the layout of your matching components or tuning of the antenna as the company that manufactures the antenna has specific detail and step to follow for tuning their antennas.

Best regards,

Geoff S.

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.


Antennas: The Comparison Guide

Find the perfect antenna for your project