asked by
Matching network for WEii 2.4 GHz SRCW004 antenna

What should the default component values be for the SRCW004 antenna matching network & DC blocking capacitor?



Please log in or register to answer this question.

1 Answer

answered by
selected by
Best answer
Hi Jason,

R1 as mentioned in the datasheet should start with a 0 ohm resistor. This may change to either a capacitor or an inductor depending on whether or not your center frequency shifts with the Weii is integrated into your device. The Pi matching components should initially start with a series 3.9nH inductor followed by one shunt 0.5pF capacitor. These will be adjusted to improve your return loss once the antenna center frequency is adjusted.

Best regards,

Geoff S.

Meet the moderators

Nansen Tsai

Engineering Manager Nansen has a wealth of technical RF and wireless knowledge, with particular expertise in RF development and problem-solving.

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.


Antennas: The Comparison Guide

Find the perfect antenna for your project