asked by
recategorized by
M20050 and conformal coatings
We have a conformal coat on our target board and will be using the M20050 module. I am looking for ways to verify the tuning once populated.

1. Can the module and tuning components be conformal coated? If not, what would be a recommended keepout area for the coating?

2. Is there a means to verify the tuning of the module once implemented?

3. Is there a way to qualify the tuning with a VNA?

Please log in or register to answer this question.

Meet the moderators

Nansen Tsai

Engineering Manager Nansen has a wealth of technical RF and wireless knowledge, with particular expertise in RF development and problem-solving.

Geoff Schulteis

Senior Antenna Apps Specialist at Antenova Geoff is an antenna design-in and OTA measurement specialist. His knowledge of FCC and world carrier requirements is second-to-none.

Steve Bradburn

Senior Antenna Engineer at Antenova With over 25 years’ experience in manufacturing, test and design, Steve has a wealth of RF and measurement knowledge across many industry sectors.


Antennas: The Comparison Guide

Find the perfect antenna for your project