QUESTION

asked by
m20050 not finding sats
Hi - I have a m20050 on a custom PCB. I have it pushing comms over uart to an arduino to see what it's reporting. It reports the GPS sentences back but never finds any satellites visible even outside in open air. There is nothing else on the PCB except the m20050 and supporting components as per the sample circuit in the datasheet. What should I look for as to the problem? Could there be a dry joint or other soldering issue that might cause the chip to be powered, report NMEA sentences correctly over TX/RX but never find a satellite?

Thanks!

Please log in or register to answer this question.

2 Answers

answered by

Hello Naz_st,

I believe you are on the right track with a possible reflow issue with the solder possibly shorting one of the pads or not making sufficient contact via cold solder joints. The next steps to check would be to re-check the instructions on the data sheet under the External Matching section to verify there's no post integration de-tuning. I'd start with those suggestions and check back if you're still having issues.

Thanks,

Dan

commented by

The circuit I'm using is the exact schematic from the datasheet (see below), with nothing else on the PCB (except pin headers to connect to external IC, and those well away from the antenna) and no enclosure.  I have included the 1.8nH inductor as specified in the example circuit... is it possible this is not needed and I should 0Ohm Res the junction instead?

answered by
Hi, the internal antenna requires a tuning circuit to ensure its on tune with the GNSS frequency bands. I think the first step would be to have your PCB files checked by Antenova support. Please can you contact techsupport@antenova.com

Thanks
commented by
Thanks - it's the same circuit as in the datasheet, but I'll send the PCB files to support as you suggest and see if they spot anything off about it.
commented by
Was this issue resolved? I am also having the same problem. Followed the PCB and circuit design in the datasheet, am able to watch the MNEA messages on the UART, but GSV indicates no satellites.
commented by
Hi,

As far as we know this issue was resolved, I would suggest we go through the same process, checking your layout first. Please contact techsupport@antenova.com so we can put you in touch with your regional support engineer.

Many Thanks

Steve

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.

download-guide-image

Antennas: The Comparison Guide

Find the perfect antenna for your project

Download
...