asked by
Is my design suitable for LTE Antenna ?

I am designing a pcb using the SR4L034-R antenna. The design of the pcb for mechanical assembly means that we have a hole (not plated) near the antenna feed track (still some GND copper around but there is 3mm without via shielding), and I'm forced to route this same track through a via (Bottom to Top). I'd like to know if this is suitable as a design or if I can improve it.

Please log in or register to answer this question.

1 Answer

answered by

I have contacted you by email.

Best regards,

Yu Kai Yeung

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.


Antennas: The Comparison Guide

Find the perfect antenna for your project