QUESTION

asked by
M20050 not fixing to satellite

I am using the M20050-1 as the GPS for our student built flight computer, following the design guidelines on the data sheet and from tech support. However during testing, we received commands such as “$GLGSV,1,1,00*65\n’” and “$GNVTG,0.00,T,,M,0.00,N,0.00,K,N*2C\n’” when interfacing the GPS with a Raspberry Pi Zero, and are not able to receive coordinates from the GPS. We suspect that the GPS is not fixing to the satellite.

I was wondering how would you recommend to approach the issue? I read on the data sheet about an external antenna, how should the external antenna be used and would it help fix to the satellite? 

Please log in or register to answer this question.

1 Answer

answered by
Hi, I would recommend moving the RaspberryPi far away, it is unscreened so it's likely to be emitting lots of noise.  If the GPS starts working when the RPi is far away, then you could look into putting a screen over the RPi.  Could you change to the Pi Pico, as that should have lower noise emissions, and should be fast enough to record the data?

Michael
commented by
Hi Michael,

Thank you for the advice! I tried moving the raspberry pi far from the M20050-1, but was still unable to locate a satellite fix. I was wondering if you have any recommendation on attaching an external antenna or information of the external antenna module discussed in the data sheet?

Best,

Hong-Ye
commented by
Hi, If it still does not track satellites when RPi is far away, then I think there is a problem with the on-board antenna, have you followed the suggested circuit for the antenna, there is a component on each side of the antenna, and the module should have a ground plane with a clearance area under the antenna. Also there is a capacitor between pin 4 and pin 6. Please could you send some pictures of the design to techsupport@antenova.com . Michael

Meet the moderators

Yu Kai Yeung

Antenna Engineer at Antenova Yu Kai is an antenna expert with over 10 years of experience in the design and testing of antennas. He has experience helping customers with certification testing, combined with his knowledge of RF measurement procedures.

Raymond Lee

Senior Antenna Engineer at Antenova Raymond has a wealth of experience in RF and antennas across many industry sectors. He has over 20 years of experience in electronics design and manufacturing.

download-guide-image

Antennas: The Comparison Guide

Find the perfect antenna for your project

Download
...